What is the structure of the deep well pump?

Before starting the pump, the suction pipe and pump must be filled with liquid. After the pump is turned on, the impeller rotates at high speed, and the liquid in it rotates with the blades. Under the action of centrifugal force, it flies away from the impeller and shoots out. The speed of the injected liquid in the diffusion chamber of the pump casing gradually slows down and the pressure gradually increases. Outlet, the discharge pipe flows out. At this time, at the center of the blade, the liquid is thrown around to form a vacuum low pressure zone with neither air nor liquid. The liquid in the liquid pool flows into the pump through the suction pipe under the action of the atmospheric pressure on the pool surface, and the liquid is continuous like this It is continuously sucked up from the liquid pool and continuously flows out of the discharge pipe.

Basic parameters: including flow, head, pump speed, supporting power, rated current, efficiency, water outlet pipe diameter, etc.

Submersible pump composition: It is composed of a control cabinet, a submersible cable, a lifting pipe, a submersible electric pump and a submersible motor.

Scope of use: including mine rescue, construction drainage, water and agriculture drainage, industrial water recycling, urban and rural residents' water supply, and even emergency rescue and disaster relief, etc.