Home > Knowledge > Content
Protection after the centrifugal pump is stopped
- Jul 13, 2018 -

Even the best pumps, if not maintained, will not achieve higher efficiency, so we must pay attention to some basic requirements in the process of using centrifugal pumps. The following describes the requirements for the centrifugal pump to stop running.

1. After the centrifugal pump stops running, close the inlet valve of the pump. After the pump is cooled, close the valve of the auxiliary system.

2, high-temperature pump parking should be carried out in accordance with the provisions of the equipment technical documents, after parking, should be half a turn every 20 to 30 minutes until the pump temperature drops to 50 °C.

3. When the cryopump is parked, when there is no special requirement, the pump should always be filled with liquid; the suction valve and the discharge valve should be kept normally open; the cryopump with double mechanical seal, the liquid level controller and the seal in the pump seal cavity The liquid should maintain the pumping pressure of the pump.

4. Centrifugal pumps that transport crystals that are easy to crystallize, easy to solidify, and easy to precipitate. Stop the pump and prevent clogging, and flush the pump and pipeline with clean water or other medium in time.

5. Drain the liquid accumulated in the pump to prevent rust and cracking.

Centrifugal pumps can be widely used in the power, metallurgy, coal, building materials and other industries to transport slurry containing solid particles. Such as thermal power plant ash removal, metallurgical ore dressing slurry transport, coal washing plant coal slurry and heavy medium transport. When the centrifugal pump is working, the pump needs to be placed on the land, the suction pipe is placed in the water, and the pump needs to be started. Due to the structural limitations of the mud pump and the submerged centrifugal pump, the motor needs to be placed above the water surface during operation, and the pump is placed in the water, so it must be fixed. Otherwise, the motor will fall into the water and the motor will be scrapped. Moreover, since the length of the long shaft is generally fixed, the installation of the pump is troublesome, and the application is subject to many restrictions.

Previous: Centrifugal pump repair and maintenance FAQ

Next: No Information

Related Products