What are the characteristics and advantages of solar pump?

1. Long life, no maintenance, small size, high efficiency, low power consumption, strong anti-interference ability and stable operation

2. No carbon brush, no pollution, electronic change  direction, long life.

3. The stator and circuit board of the motor are sealed with epoxy resin and completely isolated from the rotor, which solves the leakage problem caused by long-term diving of the motor type DC pump, and can be installed underwater and completely waterproof

4. The pump parameters can be adjusted according to the customer's requirements. The 24V water pump can modulate the head of 2m or 7m, with the same volume and wide voltage operation.

5. The high-performance ceramic shaft (stainless steel shaft can be selected to reduce the cost) is used for the pump axis, which has high precision and good wear resistance. Due to the precise matching between the high-precision shaft sleeve and the ceramic shaft (other materials can be replaced when the cost is reduced), the noise is low, and the noise can even reach below 30 dB.

6. The three-phase non hall program driven DC water pump can realize PWM speed regulation, analog signal (0 ~ 5V) speed regulation, and potentiometer VR manual speed regulation. In this way, the flow and head can be adjusted, and music fountain can be customized.

7. The three-phase DC water pump in the water pump is soft start, no impact, low starting power consumption, the circuit board is completely separated from the pump body, there is no electronic components in the pump body, the pump body is made of high temperature resistant material, and the water pump can be used in 100 ℃ water temperature for a long time. It has impeller rotor blocking protection, reverse connection protection, overload protection and over-current protection.

8. The water pump interface is rich, 4-point thread, 2-point thread, 8mm, 10mm, 22mm, 27mm, etc. it can also be customized according to customer requirements

9. If the pump head needs to be increased, the water pump can be connected in series, and the head can be doubled.

10. Amphibious (for external use, the installation position is lower than the liquid level)

11. The pump and its associated control system can be customized according to the user's requirements.