What are the components of Brushless DC solar submersible pump?

The brushless DC water pump adopts electronic components to change direction without using carbon brush. Wear resistant ceramic shaft and ceramic shaft sleeve are used. The shaft sleeve is integrated with magnet through injection molding, so the service life of Brushless DC magnetic water pump is enhanced. The stator part and rotor part of the magnetic isolation water pump are completely isolated. The stator and circuit board part are sealed with epoxy resin, which has good waterproof performance. The rotor part is made of permanent magnet. The pump body is made of environmental protection materials, with low noise, small volume and stable performance. The stator winding can be used to adjust various parameters required, and it can operate under wide voltage.

the satator and circuit board part are sealed with epoxy adpot

Advantages: long life, low noise, up to 35dB, high temperature resistance, can be used for hot water circulation. The stator and circuit board of the motor are sealed with epoxy resin and completely isolated from the rotor, which can be installed underwater and waterproof. The shaft of the water pump is made of ceramic shaft, which has good seismic resistance.